Infra-Red illuminator, Flip-up headset

NOTE: We suggest that you focus the diopter during daylight with the filter on.

Next focus the front lens until the image and the grain are both sharp. When you are in low-light con- ditions and the daylight filter is off, you may focus the front lens to receive sharp image, the diopter should not be adjusted.

NOTE: The front lens should be readjusted as you view objects at different distances.

Infra-Red illuminator

Built-in Infra-red Illuminator

Infra-red illuminators, or IR illuminators, are common to night vision. The IR light greatly enhances the performance of the PS-23 while remaining almost totally invisible to the naked eye.

To turn the IR on, draw and rotate the operation knob to “IR” posi- tion.

It is important to remember that the IR illuminator is simply an infra red light source, and like any light source, it may loose its effective- ness over a great distance.

flip-up headset

FITTING THE HEADGEAR

1)Fit the head gear to your head size. Adjust the head gear fist before attaching the PS-23 to it.

2)Loosen all the straps and place the head gear onyour head.

3)Tighten the straps until the head gear fits firmly.

GOOGLES INSTALLATION AND AJUSTMENT

Now you are ready to mount the PS-23 on to your headgear.

1)Remove the already adjusted head gear from your head.

2)Push button [1] and insert the bracket [2] of the PS-23 to the rail of the headset.

3)Place the head gear with PS-23 onto your head.

4)Loosen the screw [3] and move the unit along the rail for eye relief adjustment .

The PS-23 headset has a flip-up mechanism. Push the button [4] on the side of mount and lift the unit up until the unit fixates in the top position.

Push same button to lower PS-23 to viewing position.

Protective system

The automatic highlight protective system analyzes light exposure with the sensor . If the level of light exposure exceeds allowable the red indicator will turn on. If high light exposure is kept more than 10 seconds the device automatically will off. If you move the unit away from the bright light after it shuts off the unit will turn back on. If short-term actuation of a sight in a highlight condition(for check of serviceability)is necessary the sensor should be closed by a cover.

NOTE: The automatic highlight protective system and automatic brightness control system do not protect a sight from damage by bright light sources (a fire, headlights of the automobile, lanterns, etc.). Do not point the device at a bright light source.