Sears BFPR100 owner manual E P

Page 10

S T E P

1

Be careful to assemble all components

in the sequence they are presented.

NOTE:

Finger tighten all hardware in this step. DO NOT wrench tighten until the last step. Some components may be pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench tighten to fully go on.

1A. Install four Foot Caps (#5) in Frame A (A) and Frame B (B).

1B. Install two Clip-On Spacers (#6) on Frame A (A) and Frame B (B).

1C. Attach Frame A (A) and Frame B (B) to Frame C (C) using: 4 - (#1) M10X70mm Hex Head Bolt

8 - (#3) ø11Xø30X2.5mm Flat Washer

4 - (#4) M10 Nylon Lock Nut

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents BFPR100 WA RN I N G Table of Contents Important Safety Instructions Preparation PFPR100 Hardware List Hardware Illustration Part LIST/ILLUSTRATION Page E P Above shows assembled and completed 2A. Attach two Frame D D to Frame a a using E P E P E P Sequence they are presented E P Exploded View Diagram Page BFPR100
Top Page Image Contents