Sears 850 user manual Make sure that the Wire Harness is not pinched

Page 6

3.With the help of a second person, hold the Console Base

(6) and the Right Handrail (32) near the right Upright (14) as shown. Insert the Wire Harness (26) down into the right Upright; bend the Wire Harness, if necessary. Next, route the Wire Harness through the bracket on the Right Handrail and insert the bracket into the right Upright.

Make sure that the Wire Harness is not pinched.

Refer to the inset drawing. Slide the Strain Relief Clip (88) onto the Wire Harness (26). Make sure that there is no slack in the Wire Harness between the Strain Relief Clip and the Console Base (6). Insert a 3/4” Screw (91) into the Strain Relief Clip and into the indicated hole in the Right Handrail (32). Tighten the Screw into the Console Base.

IMPORTANT: The Strain Relief Clip (88) must be attached as instructed.

4.Attach the Console Base (6) to the Left and Right Handrails (2, 32) with three 3/4” Screws (91).

5.Thread a Handrail Bolt (15) with a Handrail Washer (16) into the right Upright (14) and the Right Handrail (32). Do not tighten the Handrail Bolt yet.

Attach the lower end of the Right Handrail (32) to the Extension Leg (41) with a 3 1/2” Handrail Bolt (89), a 3/8” Washer (61), and a Flange Nut (57).

Tighten all parts used in this step and in step 2.

6.Attach the Storage Latch (12) to the left Upright (14) with two 1/2” Screws (13). Be careful not to overtighten the Screws.

7.Remove the backing from the Adhesive Clip (74). Press the Adhesive Clip onto the base of the Uprights (14) in the indicated location. Press the Allen Wrench (73) into the Adhesive Clip.

8.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.

3

 

 

 

6

 

 

 

Bracket

88

 

 

32

91

6

 

 

88

 

26

32

 

 

 

 

14

 

 

 

 

26

91

 

 

 

4

 

 

 

 

6

 

 

32

91

2

 

 

 

 

91

5

 

 

 

 

 

 

15

 

 

 

16

 

32

 

 

 

 

 

14

57

41

 

 

 

 

 

61 89

6

 

 

 

14

 

 

 

 

 

12

13

 

 

 

7

 

 

 

 

 

 

14

 

 

 

73

 

 

74

 

6

Image 6
Contents Model No Serial No SEARS, Roebuck and CO., Hoffman ESTATES, ILTable of Contents Important PrecautionsPage Before YOU Begin Left Side Right SideAssembly Driver , adjustable wrench , and scissorsHandrail Bolt yet Make sure that the Wire Harness is not pinched Tighten all parts used in this step and in stepOperation and Adjustment HOW to Plug in the Power CordPerformant Lubetm Walking Belt Insert the key fully into the power switch Diagram of the ConsoleBattery Installation AA batteriesChange the incline of the treadmill, if desired Reset the speed controlStart the walking belt FAT CaloriesHOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Maintenance and TROUBLE-SHOOTING Problem The power turns off during useTop Problem The walking belt slows when walked on Problem The walking belt is off-center when walked onProblem The walking belt slips when walked on Exercise Intensity HOW to Measure Your Heart RateConditioning Guidelines Workout GuidelinesSuggested Stretches Part LIST-Model No Key No. Part No. Qty DescriptionExploded DRAWING-Model No Lifestyler Expanse Full 90 DAY WarrantyModel No SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL