ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all packing materials from your area and place them back into the box. Do not dispose of the packing materials until assembly is completed. Read each step carefully before beginning. If you are missing a part please call our
parts@staminaproducts.com
STEP 1
Remove your PILATES PREMIER from its packaging placing the product on its side, with the LOCKING PIN(26) side upward. Remove the LOCKING PIN(26) and unfold the MAIN FRAME ASSEMBLY to a flat position by moving the FRONT FRAME(1) away from the platform end of the product in a clockwise position until fully extended.
STEP 2
Remove the paper covering from the foam tape inside the FRONT END COVER(6) and REAR END COVER(7). Place the FRONT END COVER(6) over the FRONT FRAME(1). Press the FRONT END COVER(6) securely in place. Place the REAR END COVER(7) over the REAR FRAME(2). Press the REAR END COVER(7) securely in place.
NOTE: The securing SCREWS(M6 x 35mm)(37) for the PULLEY ASSEMBLY(22) on each side may need to be loosened to allow the REAR END COVER(7) to fit securely over the frame. Refer to illustration. When retightening the screws for the PULLEY ASSEMBLY(22) do not over tighten. The PULLEY ASSEMBLY(22) should move freely.
5