DIAGRAM OF THE CONSOLE
Monitor Displays | LED Track |
Incline Control | Clip | Key | Speed Control | Pulse Sensor |
CAUTION: Before operating the console, read the following precautions.
¥Do not stand on the walking belt when turning on the power.
¥Always wear the clip (see the drawing above) while using the treadmill. When the key is removed from the console, the walking belt will stop.
¥Adjust the speed in small increments.
¥The settings marked above the speed control
¥To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and use only a sealed water bottle.
STEP BY STEP CONSOLE OPERATION | 2 | Reset the speed control. | ||||||
If there is a thin sheet of clear plastic on the face of the |
| Slide the speed |
|
| ||||
|
|
|
|
|
|
| ||
console, remove it. Next, make sure that the power |
| control to the |
|
| ||||
cord is properly plugged in (see HOW TO PLUG IN |
| the RESET |
|
|
|
|
|
|
THE POWER CORD on page 7). |
| position. Note: |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
| Each time the |
|
| ||||
Stand on the foot rails of the treadmill. Find the clip |
| walking belt is |
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| |||
attached to the key (see the drawing above), and |
| stopped, the |
|
| ||||
slide the clip onto the waistband of your clothing. |
| speed control must be moved to the RESET po- | ||||||
|
| sition before the walking belt can be restarted. | ||||||
Follow the steps below to operate the console. |
|
|
|
|
|
|
|
|
1Insert the key fully into the power switch.
After a moment, the
four displays and one indicator in the LED track will light.
3Start the walking belt.
Slowly slide the speed control to the right until the walking belt begins to move at slow speed. Step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by sliding the speed control.
To stop the walking belt, step onto the foot rails and slide the speed control to the RESET posi- tion. After a few seconds, the displays will pause.
8