®
Follow instructions and warnings to avoid fires, serious injury, or death.
WARNING:
1.Coleman® fuel is extremely flammable, handle with extreme care. Fuel vapors are invisible, explosive, and can be ignited by ignition sources many feet away.
2.This lantern is designed to use Coleman fuel. Never use kerosene, unleaded or leaded automotive fuel.
3.Store fuel in a clean, properly marked container away from flame (including pilot lights), other sources of ignition, or excessive heat.
4.Always fill outdoors. Never fill lantern, loosen or remove fuel cap while lantern is lighted, near flame (including pilot lights), other ignition sources, or while top of lantern is hot to touch.
5.Always light and use lantern outdoors; never inside house, camper, tent, or other unventilated or enclosed areas.
6.This lantern consumes air (oxygen). Do not use in unventilated or enclosed areas to avoid endangering your life.
7.Keep lantern away from flammables. Never allow fabric, clothing, or any flammable material to come within 4 ft. (1.2 m) of the top and 1 ft. (30 cm) of the side of the lantern.
8.Use for lighting only. Never alter in any way or use with any device or part not expressly approved by Coleman. Do not use as a space heater.
9.Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard.
10.Keep out of reach of children.
Filling the lantern
■Always fill outdoors. Never fill lantern, loosen or remove fuel cap while lantern is lighted, near flame (including pilot lights), other ignition sources, or while top of lantern is hot to touch.
■Turn FUEL VALVE to OFF.
■Close PUMP KNOB firmly. Turn in direction of arrow.
■Remove FUEL CAP. Use a funnel or suitable filling device and fill with clean, fresh fuel. Lantern must be in a level position.
DO NOT TIP.
■Replace FUEL CAP on lantern and on fuel container. Tighten firmly. WIPE UP ANY SPILLED FUEL AND DIS- POSE OF IN A SAFE PLACE.
To tie on mantle
■Always use genuine Coleman® mantles. Replace dam- aged mantles to avoid overheating or damaging lantern.
■Unscrew ball nut at top of lantern and remove ventilator and glass globe.
■Tie mantle around groove in burner and cut off ends of string 1/4" (.64 cm) from knot.
■Light bottom of mantle evenly (move match back and forth) and leave to burn. Once mantle has been burned it is very fragile. Be careful not to touch it with your finger or with a match.
■Replace the glass globe, venti- lator and ball nut.
Pumping
■Be sure fuel valve is off and fuel cap is firmly closed.
■Open pump knob by turning 1 full turn to the left.
■Cover hole in pump knob with thumb and pump approximately 30 full strokes.
■Close pump knob.
Lighting the lantern
■Always light and use your lantern outdoors; never in house, camper, tent or other unventilated or enclosed areas.
■Push a lit match through lighting hole and turn fuel valve to high. CAU- TION: Flames other than at mantle indicate flooding or a leak. Turn FUEL VALVE OFF, allow flames to burn out and lantern to cool. Carefully review instructions and correct problem before relighting lantern.
■Open pump knob and pump
■Adjust fuel valve to desired brightness.
■To clean generator tip, turn fuel valve from high to off to high several times.
■Good air pressure is important. Maintain pressure by periodic pumping.
To Turn Off
■Turn the lantern off by turning fuel valve to “OFF.” Light will dim and go out in