Coleman 2000001106 manual Cooler Access, Electrical Cord Access, To Store, Things You Should Know

Page 2

To Attach Rainfly continued

5.Turn rainfly over and drape over tent making sure ridge pole is centered over the door. (Fig. 5)

NOTE: When positioned properly, seams on rainfly will always align with poles on tent.

6.Attach hook & loop fasteners, located on seams of the underside of rainfly, around the black main poles, to secure. (Fig. 5A)

7.Clip hooks on elastic cords, on the front and back corners of rainfly, onto metal loops at front and back corners of tent. (Fig. 5B)

8.Tie guylines through loops on web straps on the rainfly. (Fig. 5C)

9.Stretch guylines until taut, then secure with stakes. (Fig. 5D)

Black Main

Pole

5C

5A

Fig. 5

5D

5B

Cooler Access

The smaller zippered opening at the rear of the tent is designed for added ventilation and easy access to your beverage cooler.

1.To use as a vent, unzip flap to

expose screen. (Fig. 6)

Fig. 6

 

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into the tent.

(Fig. 7)

Fig. 7

Electrical Cord Access

1.Unzip access panel in the lower right corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 8)

Fig. 8

To Store

1.All metal poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2007 The Coleman Company, Inc.

Coleman® and are registered trademarks of The Coleman Company, Inc.

12/07

STITCH LINE

Image 2
Contents Parts and Components To Set Up TentBefore you begin To Attach RainflyTo Store Cooler AccessElectrical Cord Access Things You Should Know