Coleman 5177 manual To Turn Off, To Store, Match Light Lantern, Electronic Ignition Lantern

Fig. 17

.2"

(5.0 mm)

nAssemble reflector to back of lantern. Position the reflector clips onto the center of the two back rails and

slide either upward into the reflecting position­or downward into the storage position. (Fig. 12)

Fig. 12

NOTE: If lantern does not light, repeat above step. If the lantern does not light after several attempts, check for a spark while clicking the igniter. If no spark is present, check the electrode gap. The gap should be about .2" (5.0 mm). Carefully bend electrode to set gap. If the lantern is wet due to rain,

high humidity, etc., the electrode may not spark. Use lighting procedure for match light version

n Reflecting position.

Bottom tab rests

n Storage position.

Reflector hangs from

lanterns. (Fig. 17)

inside lantern frame.

(Fig. 13)

back rails. (Fig. 14)

nBrightness may be adjusted with fuel valve. (Fig. 18)

Fig. 18

To Turn Off

nTurn fuel valve off. (Fig. 19)

CAUTION

•SERVICE SAFETY

•Keep all connections and fittings clean. Inspect propane cylinder and lantern propane connections for damage before attaching.

•During set up, check all connections and fittings for leaks using soapy water. Bubbles indicate a leak. Never use a flame.

To Store

Match Light

Lantern

nPush lighted match through lighting hole, hold near mantle and open fuel valve fully. (Fig. 15)

Fig. 15

INSTASTART™

Electronic

Ignition Lantern

nOpen burner valve and repeatedly push igniter button and ignite the mantles. (Fig. 16)

Fig.16

n Make sure lantern is cool.

n Move lantern away from flame (including pilot lights) and other ignition sources.

n Remove propane cylinder from lantern. (Fig. 20)

n Replace protective cap

on propane cylinder.­

Fig. 20

n Lantern can be placed in base for secure storage. (Fig. 21)

Fig. 21

DANGER

WARNING

•BURN HAZARD

•Never leave lantern unattended when hot or in use.

•Keep out of reach of children.

•EXPLOSION - FIRE HAZARD

•Never store propane near high heat, open flames, pilot lights, direct sunlight, other igni- tion sources or where temperatures exceed 120 °F (49 °C).

•The cylinder must be disconnected when the lantern is in storage.

English - 4