Coleman 9277-907 manual Door and Window Vents, Cooler Access, Electical Cord Access, To Store

Page 2

To Attach Rainfly continued

7. Extend front

Guyline

flaps on rainfly

and secure with

 

stakes. (Fig. 13)

 

Note: Flaps may be

 

rolled back and and

 

secured by inserting

 

toggles through

 

fabric loops. (Fig. 14)

 

 

 

Fig. 13

 

 

 

 

 

8.Attach guylines to web straps on rain fly and stake out.

Fig. 14

Door and Window Vents

1.To use the door vent, undo other zipper to expose vent, then roll up door flap and fasten with toggle and fabric loop. (Fig. 15)

Fig. 15

2.To open back and side window vents for more ventilation, unzip, then roll up and insert toggles through fabric loops. (Fig. 16)

Fig. 16

Cooler Access

The smaller zippered opening at the rear of the tent is designed for added ventilation and easy access to your beverage cooler.

1.To use as a vent, unzip flap to

expose screen. (Fig.17)

Fig. 17

 

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into the tent.

(Fig.18)

Fig. 18

Electical Cord Access

1.Unzip access panel in the lower right corner of tent and bring in electrical cord.

Use only UL approved cords that are rated for outdoor usage. (Fig. 19)

Fig. 19

To Store

1.All metal poles and stakes must to be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

Stakes should be removed by pulling on the stake itself. Never pull on the tent to remove stake.

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2006 The Coleman Company, Inc.

Coleman® and are registered trademarks of The Coleman Company, Inc.

11/06 Rev

STITCH LINE

Image 2
Contents Parts and Components To Set Up TentBefore you begin To Attach RainflyDoor and Window Vents Cooler AccessElectical Cord Access To Store