Coleman 2000001379 manual Cedar Pass 8’x7’, Connect Frame to Tent

Page 1

CEDAR PASS8’x7’

Instructions apply to Part Number 2000001379

When You Are Ready

To Set Up Your Tent

Select a level campsite clear of rocks, branches and other hard or sharp objects.

Do not set up your tent under trees.

For best results in windy conditions, do not position the door of tent into the wind.

 

POLE ASSEMBLY PARTS

Main Tent

Part No. 9240-1031

Poles

 

 

 

 

 

 

 

 

 

 

Rainfly Pole

Part No. 9240-1041

 

 

 

 

 

 

Rainfly Part No. 5010000492

1 Layout & Positioning of Tent, Pole Assembly

Layout and position tent with door facing desired direction. (illus. 1)

Unzip door.

Stake down tent corners only, using the rings at the end of the stake loops. Keep the floor taut. (illus. 2)

Assemble frame poles by interlocking shock-corded poles. This will make two long poles.

Insert the poles diagonally into pole sleeves. The center of the poles should cross forming an “X” in the middle of tent. (illus. 1)

Assembled poles inserted through pole sleeves

illus. 1

2 Connect Frame to Tent

– Insert one end of main tent pole end onto pin of pin & ring system, at tent corner. (illus. 3)

– Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole.

– Repeat for second pole. (illus. 4)

illus. 4

Tent frame set-up

illus. 2

Tent stake through ring

illus. 3

Insert pole end onto pin & ring

Image 1
Contents When You Are Ready To Set Up Your Tent Layout & Positioning of Tent, Pole AssemblyCedar Pass 8’x7’ Connect Frame to TentAttach Rainfly Attach Tent to Frame Using Frame ClipsThings You Should Know