To Set Up Tent’s Screen Room continued
3.Insert one end of each gray screen room pole into remaining pins on tent. Gradually apply pressure to other end of pole to form an arch & insert into other front pin. (Fig. 6, 6A, & 6B)
4.Attach frame clips along edges of screen room
to gray poles. (Fig. 6C) | 6C |
Fig. 6
6A
6B
5.Stretch tent until taut, then secure metal loops and web straps with stakes. (Fig. 7)
Fig. 7
To Attach Rainfly
1.Drape rainfly over living quarters and screen room of tent with as shown. (Fig 8).
NOTE: Hook and loop fasteners, located on seams of under side of rainfly, should be centered over black and gray poles.
2.Locate all hook & loop fasteners on underside of rainfly and wrap around black and gray poles to secure. (Fig. 8A)
3.Stretch elastic straps and hook clip on each to the metal loops around the tent as shown. (Fig. 8 & 8B)
8A |
Rainfly |
8B |
Fig. 8 |
4.Tie guylines through loops on web straps on the rainfly. (Fig. 9)
5.Stretch guylines until taut, then secure with
stakes. (Fig.10) | Fig. 9 | Fig. 10 |
Electrical Cord Access
1.Unzip access panel in the lower right corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 11)
Fig. 11
Rainfly Configurations for Screen Room
The rainly offers you the ability to choose various configurations to fully utilize your tent’s screen room for maximum ventilation or for privacy and protection from the elements.
Fig. 12
Rainfly
unhooked &
rolled back
for maximum
airflow
Fig. 13
Rainfly door flap rolled &
secured
Cooler Access |
|
The smaller zippered opening at the |
|
rear of the tent is designed for added |
|
ventilation and easy access to your |
|
beverage cooler. (Fig. 14) | Fig. 14 |
To Store
1.All metal poles and stakes must to be placed in the storage bag to prevent damage to the fabric items placed in the carry case.
2.Make sure tent is clean and dry before placing in carry case.
3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.
4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.
5.Store in a clean, dry area.
Things You Should Know:
•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.
•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.
•Do not leave your tent
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
| MADE IN CHINA • PRINTED IN CHINA |
| © 2007 The Coleman Company, Inc. |
Coleman® and | are registered trademarks of The Coleman Company, Inc. 11/07 |
STITCH LINE