English
Instructions
Bow, Wow, Wow! Build your own barking Gears!® Coggy Doggy™. These
Before you begin, take time to identify all of the pieces, matching them to the parts guide on the following page. Also, make sure an adult properly installs 4 “AA” batteries in the motor’s hand controller. See the last page in this guide for more, important battery care information.
Building Tips
•As you build, test the motor every so often to make sure the gears are moving properly. Make sure you do not overload the motor with too many gears, as this may put a strain on the motor and cause it to fail. If you notice the gears are moving very slowly, remove some of the gears or replace the batteries.
•When attaching Crown Gears, first connect an axle with a small gear on one side. Then, place Crown Gear, connected to a half pillar with a peg on top. If you place a gear on the other side of the axle, the gears may lock up. See instruction guide for peg and half pillar assembly.
•The Gears! models will work best if gears are properly attached and touching the floor, as well as moving in the same direction on both sides. Test this by placing the model on the floor and push the forward and backward buttons on the motor.
•When building the Coggy Doggy model, make sure that the motor cord is not tangled with the gears. This could cause strain on the motor, and cause it to fail.
•The center button on the motor controller is for doggy sounds. Press this button to hear an assortment of sounds played one at a time. The sounds will automatically shut off until the button is pushed again.
•Keep the box that this product was packaged in for storage.
figure 1
WRONG!CORRECT!
1