GETTING STARTED
The first thing you need to do when you take your BISCUIT puppy out of the box is to insert batteries.
TO INSTALL BATTERIES
Note to the consumer: To install batteries in your puppy, lay him down on his back first. This will make the installation process much easier.
Use a Phillips/cross head screwdriver (not included) to loosen screw in battery compartment (screw remains attached). Take
CAUTION: TO AVOID BATTERY LEAKAGE
1.Be sure to insert the batteries correctly and always follow the toy and battery manufacturers’ instructions;
2.Do not mix old batteries and new batteries or alkaline,
standard
3.Always remove weak or dead batteries from the product.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
PLAYING OPTIONS
Play Mode
Biscuit responds to your touch and your voice. The more you play with him, the happier he will be!
Response Mode
If Biscuit hears speech that is not a speech command, he’ll respond with puppy sounds.
Hangout Mode
After a few moments of
After a few minutes in hangout mode, your puppy will go to “sleep”: he’ll lay down and start snoring! If the room is dark or dimly lit, Biscuit will go to “sleep” much faster than if the room is bright.
To “wake” him, and return to Play Mode, clap twice or wave your hand over his forehead.
LIGHT SENSOR FEATURE
If it is dark in the room and the lights come on suddenly while your puppy is “asleep”, he’ll lift his head and open his eyes and make a little mumbling noise. If you don’t pet your puppy within about 10 seconds, he will go back to “sleep”.
off the door and insert 6 x 1.5V “D” or LR20 size alkaline batteries.
Place door back over batteries. Push down on door; hold door down with one hand and use other hand to tighten screw.
NOTE: The toy uses battery power whenever switch is in the “ON” position. To conserve batteries, move switch to “OFF” position when you’re not playing with your puppy.
1.Always follow the instructions carefully. Use only batteries specified and be sure to insert item correctly by matching the + and – polarity markings.
2.Do not mix old batteries and new batteries or standard (carbon- zinc) with alkaline batteries.
3.Remove exhausted or dead batteries from the product.
4.Remove batteries if product is not to be played with for a long time.
5.Do not
6.Should this product cause, or be affected by, local electrical interference, move it away from other electrical equipment. Reset (switching off and back on again or removing and re- inserting batteries) if necessary.
7.RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
CLEANING INSTRUCTIONS
To clean your puppy, gently brush him with a cloth or soft brush to loosen any dirt. Then use a slightly damp cloth to remove stains.
•To prevent staining, wipe off dirt immediately.
•Do not get wet; to remove stains use only a slightly damp cloth.
•Do not use detergent or stain removers.
•If puppy gets wet, remove batteries and let dry; once puppy is completely dry, replace batteries.
•Avoid spilling food or beverages on the puppy.
•Do not throw or kick the puppy, and do not push sharp objects through the speaker openings.
•Do not leave puppy in direct sunlight; high temperatures will destroy the mechanism.
1 | 6 |