Hasbro AGE 3+ manual Important Battery Information, To Replace Batteries

Page 3

TO REPLACE

BATTERIES

Use a Phillips screwdriver to loosen screw in battery compartment door (screw remains attached to door). Remove door and remove old batteries. Insert 3 x 1.5V fresh "AA"/LR6 alkaline batteries. Replace door and tighten screw.

CAUTION: TO AVOID BATTERY LEAKAGE

1)Be sure to insert the batteries correctly and always follow the toy and battery manufacturer’s instructions.

2)Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

3)Always remove weak or dead batteries from the product.

IMPORTANT: BATTERY INFORMATION

Please retain this information for future reference.

Batteries should be replaced by an adult.

1)Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and – polarity markings.

2)Do not mix old batteries and new batteries, or standard (carbon-zinc) with alkaline batteries.

3)Remove exhausted or dead batteries from the product.

4)Remove batteries if product is not to be played with for a long time.

5)Do not short-circuit the supply terminals.

6)Should this product cause, or be affected by, local electrical interference, move it away from the other electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if necessary.

7)RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.

Image 3
Contents Bitin’ Bruce Action stops after 5 seconds To PlayTo Replace Batteries Important Battery InformationSurface Wash only FCC Statement