Using the Remote Control
Receiver/Amplifier Operation
Before operation, press TUNER to select receiver/amplifier operation.
TUNER
STATION
BAND
TUNING
MPX
CLASS
DIRECT ACCESS
Number Buttons
– SW LEVEL+
Tunes to the next higher or lower memory location.
Selects the AM or FM tuner band.
Tunes to radio stations.
Selects the FM reception mode.
Selects the memory class.
Allows direct input of the station frequency.
Select the corresponding memory station. During Direct Access, enter the station’s frequency.
Controls the sound level of the subwoofer when pressed after
SURROUND.
CONTROL
MODE
Receiver/
Amplifier
Buttons
–REAR RIGHT LEVEL+ Controls the sound level of the rear speakers when pressed after
SURROUND.
TEST TONE | Sounds test tones from each speaker when pressed after SUR- |
| ROUND. |
–REAR LEFT LEVEL+ Controls the sound level of the rear speakers when pressed after
SURROUND.
CENTER MODE | Selects among the three center modes or 3CH Logic when |
| pressed after SURROUND in Dolby |
–CENTER LEVEL + Controls the sound level of the center speaker when pressed af- ter SURROUND.
DELAY TIME | Sets the |
| grams when pressed after SURROUND. |
–EFFECT +
SURROUND
PRO LOGIC
DSP MODE
MUTING
VIRTUAL
+MASTER VOLUME –
RECEIVER POWER FUNC
DIRECT
Adjusts the level of DSP mode.
Sets the remote control into the surround setup mode.
Selects Dolby Pro Logic Surround.
Selects the DSP mode; HALL, JAZZ, DANCE, THEATER 1, or THEATER 2.
Silences the receiver. Press again to restore the sound to its pre- vious level.
Selects virtual surround mode; DOLBY VIRTUAL, SRS1, or SRS2.
Selects
Adjusts the system’s volume.
Turns the receiver on and off.
Selects a program source (VCR, PHONO, tuner, CD, DVD/TV, or LD/SAT). Repeatedly press until the display shows the desired program source.
Bypasses the receiver’s audio control circuits. Press again to re- store the previous settings.
29