WARNING: This Helmet does not provide protection for LASER AND OXYHYDROGEN welding.
1.Verify that the batteries are good.
2.Turn the helmet over and adjust the Shade Knob to the desired shade (9 ~ 13).
3.Push the Switch Button to turn the lens on and open the window.
4.Adjust the helmet Side Knobs for a proper fit. Tighten the Lens Clamp Screws.
5.Put on a pair of safety glasses first, then the helmet.
6.While looking to one side, strike an arc briefly (see # 6 above).
Check to see if the welding filter lens went dark. If it did, the
Maintenance
Replacing Batteries
1.Turn the Helmet over to expose the inside.
2.Remove the Battery Cover. Lift the right side of the battery cover and pop it out.
On / Off Button |
|
|
| Shade Control |
|
|
| ||
|
|
|
|
AAA Battery Compartment
Battery Compartment Cover
3.Remove two batteries from the battery compartment.
4.Place both new batteries negative side (left) into the battery compartment. The batteries should be completely clean of grease and dirt.
5.Replace the Battery Compartment Cover, left side first, then push in the right side until it snaps into place.
General
1.Use a clean, soft cloth to clean the Lens Filter. Do not use water or cleaning liquids.
2.Store the helmet in a cool and dry location.
SKU 47996 | Page 5 |