Cateye CC-CD200N owner manual Computer. They may damage the surface of computer, All Clear

®

CAT EYE ASTRALE 8

CYCLOCOMPUTER CC-CD200N

E: Owner’s Manual

ASTRALE8

U.S. Pat. Nos.4633216/4642606/5226340/5236759 Pat. and Design Pat. Pending Copyright © 2002/2003 CAT EYE Co. Ltd.

CCMCD2N-030531 066600252 1

•Pay attention to the road or trail! Do not be distracted by the computer.

•Keep batteries out of reach of small children. Dispose of batter- ies according to local regulations.

3 Mount The Bracket

Secure the cord by fastening it to the frame with zip ties at regular intervals.

Put the rubber pad 8 on the bracket 1 and secure the bracket on the handle bar with the

Please read these instructions carefully before installing or using the CAT EYE ASTRALE 8.

Please keep this manual in a safe place for future reference.

Installation of the Computer on Your Bike

The computer comes with the following parts:

1 Mount the wheel magnet and speed sensor

• Mount the wheel magnet 6 on a spoke of the rear wheel so the surface of the magnet faces the sensor.

• Mount the speed sensor 3 (long cord) on the left chainstay with nylon ties 9. Note The nylon ties can only be used once, please install with care.

screw. Slide the computer into the bracket until you hear the click sound. When you need to remove the computer, press the lever on the handlebar bracket and slide the computer forward.

Note Allow enough wire clearance in the area marked with to insure you can turn the handlebars all the way from side to side without pulling the wire.

1

Lever

4 Basic Functions Test

Spin the rear wheel to see if Speed is reading properly. Push the mode button until Cadence (Cdc) is in the sub-display. Spin the crank arm backwards to test if Cadence is reading properly. When you receive a signal, tightly secure the sensor so it does not move.

Note When the computer does not indicate the speed/cadence, check the position of the magnet and the sensor.

Important Note

Mount the magnets 6 and the sensors 3 in the appropriate positions so that the center of each magnet 6 aligns with the marked sensor line when the rear wheel and crank arm are rotated. The magnet should be no more than 5mm from the sensor.

Important Note

When the crank is spinning, the center of the magnet 7 should pass in front of the sensor

4marking line. The distance between the sensor and the magnet 7 should be within 5mm. After adjusting the magnet and sensor, secure tightly with nylon ties.

SET ButtonAC Button

START/STOP Button

MODE Button

AC Button

1 All Clear

Push the AC button on the backside.

* Push the AC button when using this system for the first time and every time the battery is replaced.

SET

3 Set The Tire Circumference Set the tire circumference in mm.

Note Refer to the chart shown on the right.

Setting is fixed and completed by pushing the SET button.

Increase the number

Max. 2999 mm

MODE

SET

Decrease the number Min. 10 mm

START/STOP

Preparation Complete.

(the screen will show the time measurement in this state)

* The auto mode is ON in this state.

Tire size is usually shown on the sidewall of tires.