Keys Fitness CZCLUBMAX owner manual Belt Adjustment and Tension

Page 17

17Belt Adjustment and Tension

WARNING! Do not over-tighten rollers! This will cause prema- ture roller bearing failure!

Belt adjustment and tension performs two functions: adjustment for tension and centering. Your new treadmill comes pre-adjusted from the factory for tension and centering. Please follow the procedures below if the belt shifts to the left or right while walking:

WALKING BELT IS SHIFTING TO THE LEFT (Diagram 1) First, turn treadmill on to run at 1 mph. Using the hex key provided, turn the left rear roller adjustment bolt ¼ turn in the clockwise direc- tion. Next, run the treadmill at 2.5 mph. You should see the belt start to correct itself by moving back towards the center. Repeat the above pro- cedure until the walking belt is centered. It may be necessary to set walk- ing belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SHIFTING TO THE RIGHT (Diagram 2) First, turn the treadmill on to run at 1 mph. Using the hex key provided, turn the right rear roller adjustment bolt ¼ turn in the clockwise direc- tion. Next, run the treadmill at 2.5 mph. You should see the belt start to correct itself, moving back towards the center. Repeat the above proce- dure until the walking belt is centered. It may be necessary to set walk- ing belt tension once you have completed this procedure if the belt feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SLIPPING DURING USE (Diagram 3) First, unplug the power cord from the surge protector. Using the hex key provided, turn both left and right rear roller adjustment bolts the same distance, usually a ¼ turn in the clockwise direction. Plug the power cord back into the surge protector and run the treadmill at 2.5 mph. You should now walk on the belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slip- ping. The tension should be just tight enough not to slip.

Turning the hex key counter clockwise brings the rear rollers and belt towards you.

Turning the hex key clockwise pushes the rear roller and belt away from you.

Image 17
Contents CardioZone Club Max HR T Treadmill Table of Contents Specification Sheet Safety Precautions and Tips Important Safety InformationBefore You Start Warm Up Exercises Assembly for main uprights Assembly InstructionsAssembly Instructions Assembly Instructions Power Requirements Console Functions and Descriptions Program and Operating Instructions Quick Start / Manual ModeProgram Mode Heart Rate Program Operation Program Instructions Heart Rate ModeHeart Rate Monitor Mode Program Instructions Heart Rate Mode Speed 11INCLINE Program ProfilesBelt Adjustment and Tension Change Miles per hour to Kilometers per hour Cleaning Maintenance InstructionsTreadmill will not start Troubleshooting GuideTreadmill Error Messages Error MessagesClub MAX HR T Treadmill Calibration SequenceParts & Diagrams Please Consult Your Physician Before Using this Product