Assembly Instructions

Minor Assembly Required!

Alliance 850 and 880HR treadmills are shipped in two pieces: the console upright assembly and the base assembly. After opening the box, remove any packing materials from the treadmill. Do not throw away any packing materials until the unit is working properly. The treadmill box contains a package that includes the Owners Manual, a RED SAFETY KEY, and a belt adjustment tool. The 880HR will also contain the heart rate chest strap. The treadmill will not

operate without the Red Safety Key.

The console upright assembly is attached to the base assembly. Place the unit on a clean, level surface near an electrical outlet (extension cords are not recommended).

1.Raise the console into an upright position. Loosely install both 3/4” buttonhead screws on each side of the upright. Install and tighten each 3 1/2” x 5/16” bolt (2) with washers from the bottom of the base frame through the upright lock (diag. 1).

2.Now tighten the buttonhead screws securely from step 1.

3.Tighten the black, flathead pivot bolts on the inside of upright.

4.Install motor hood cover using 5/8” phillips head screws (8 screws).

Be sure the treadmill is level to the floor. The rear feet can be adjusted to level the treadmill.

Assembly is now complete!