Keys Fitness HT-PRO owner manual Maintenance Instructions, To Apply Lubricant to the Walking Board

Page 22

Maintenance Instructions

WARNING! Before performing any maintenance to your treadmill, always unplug the power cord from the surge protector.

CLEANING: Routine cleaning of your unit will extend the life of your unit.

WARNING! To prevent electrical shock, be sure the power to the treadmill is OFF and the unit is unplugged from the wall electrical outlet before attempting any cleaning or maintenance. AFTER EACH WORKOUT: Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to remove excess perspiration. USE NO CHEMICALS.

WEEKLY: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.

DECK LUBRICATION: The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board be checked periodically for lubrication to ensure optimal treadmill performance. Every 30 days or 30 hours of operation, lift the sides of the walking belt and feel the top surface of the walking board as far under as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the touch, lubrication is needed. Keys Fitness recommends “Lube N Walk” for cleaning and lubricating the treadmill belt and deck. Ask your retailer or call Keys Fitness at 888-340-0482.

TO APPLY LUBRICANT TO THE WALKING BOARD

1.) Take foam wand applicator, without lube, and insert it in between the walking belt and deck, exposing the two plastic tabs at either end of thewalking belt. Take both tabs and run the wand back and fort along the entire length of your deck. Remove the applicator and prepare for lubri- cation.

2)Apply about a dime's worth of lubrication onto the side of the applicator wand hat was not used for removing dirt and debris (step 1). You can add more or less lubricant, depending on your lubrication schedule.

3)Insert the wand between the walking belt and deck, exposing the two white plastic tabs at either end of the walking belt.

4)Take both of the tabs and run the wand back and forth along the entire length of your deck. You are done until your next scheduled lubrication date.

5)Allow the silicone to ‘set’ for one minute before using the treadmill.

WARNING: Do not over-lubricate the walking board. Excess lubricant should be wiped off with a clean towel.

22

Image 22
Contents Health Trainer Pro Treadmill Table of Contents Important Safety Information Safety Precautions and TipsBefore You Start Assembly Parts ListUprights Console Harness Allen Bolt Washer Phillips Screw Congratulations Moving Instructions Power Requirements Calories / Distance Window Console Panel FunctionsIncline / Pulse Window Time / Pace WindowProgram Operation Quick Start / Manual ModePause Power Enter Program Incline Start / StopProgram Mode Customizing Programs in P1 and P2 ModeProgram Profiles Monitoring Your Heart Rate Monitoring Your Heart RateTarget Heart Rate Zone Warm Up Exercises Exercise GuidelinesChange to MPH or KPH Calibration Sequence Belt Adjustment Walking Belt is Shifting to the Left DiagramMaintenance Instructions To Apply Lubricant to the Walking BoardError Messages Treadmill Error Messages Safety Interlock Error MessagesTroubleshooting Guide Treadmill will not startParts List HT-PRO Treadmill Parts List Rev aExploded View Console Assembly Warranty Information Keys Fitness PRODUCTS, LP Limited WarrantyCustomer Service