Assembly, Your own wire cutters not included

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own wire cutters (not included).

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (80) until the treadmill is in the position shown.

2.Cut any plastic ties from the Right and Left Handrails (93, 7). Set the Right Handrail (the longer Handrail) on the right Upright (80). Have another person lift the Handrail at the indicated location. While pressing down on the Handrail at the indicated location, firmly tighten a Short Handrail Bolt (59) with a Washer (60) into the Upright and the Right Handrail.

Attach the Left Handrail (7) as described above.

3.Insert a Long Handrail Bolt (37) with a Washer (60) and a Plastic Washer (53) into the lower end of the Right Handrail (93) as shown. Finger tighten the Long Handrail Bolt into the Frame (87).

Next, hold an Upright Spacer (11) inside the lower end of the right Upright (80). Insert a Long Handrail Bolt (37) with a Washer (60) through the Upright and the Upright Spacer, and finger tighten the Upright Bolt into the Frame (87).

Repeat this step on the left side of the treadmill (not shown).

Tighten the three Long Handrail Bolts (37) on each side of the treadmill.

1
	80
2				Press
				Press
	59			Down
	59			Here
				Here
7	60
	60			59
				59
	Lift Here	93		60
	Lift Here
				80
3
		80
	93
				37
		11	60	37
		87
	60
53	37

4.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see pages 12 and 13). To protect the floor or carpet from damage, place a mat under the treadmill.