PYLE Audio PT-690A manual Before USE, Read this Before Operation, Before Connection

BEFORE USE

READ THIS BEFORE OPERATION

1.Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibration and excessive dust, cold or moisture.

2.The ventilation holes should not be covered. Make sure there is enough space above and beside the amplifier/receiver (about 4 inches). Do not place a CD player or other equipment on top of the amplifier/receiver.

3.Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If a foreign object gets into the set, contact your dealer or authorized service center.

4.When removing the power plug from the wall outlet, always pull directly on the plug, never on the cord.

5.Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry cloth.

6.Keep this manual in a safe place for future reference.

Back-up Memory Function

This is the function that preserves the preset memory and most-recent memory function. In the event of a power failure, or if the power cord of this unit is disconnected from the electric outlet, the back-up memory will preserve the preset memory and most-recent memory functions for as long as approximately 1 week.

If the power supply is interrupted for 7 days or longer, the memory settings will be erased.

When to use RESET switch

1.When this system is subjected to an electrical shock.

2.When the power is interrupted. In this case, try the following:

Switch on the POWER, use a paper clip to press the RESET button for more than 3 seconds duration.

POWER ON/OFF

DOLBY DIGITAL/DTS AVRECEIVER PT-690A

ONOFF

RESET

Note: If the RESET button is pressed for more than 3 seconds, all the current set up memory will be erased.

BEFORE CONNECTION

Caution

Turn off the power of all the equipment before making connections.

Read instructions of each component you intend to connect to this unit.

Be sure to insert each power plug securely. To prevent hum and noise, do not bundle the interconnection leads with power cord or speaker leads.

Speaker Connections

Caution:

To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers.

Check the impedance of your speakers.

Connect speaker with an impedance of 8 ohms or more. The amplifier’s red speaker terminals are the + (positive) terminals and the black terminals are the – (negative) terminals.

The + side of the speaker cable is marked to make it distinguishable from the – side of the cable. Connect this marked side to the red + terminals and the unmarked side is the black terminal.

Prepare the speaker cords for connection by stripping off approximately 10 mm or less (no more as this could cause a short-circuit) of the outer insulation. Twist the wires tightly together so that they are not straggly.

How to connect

Red: positive (+)

Black: negative (-)

1 2

3

1.Unscrew the knob

2.Insert the speaker cable.

3.Tighten the knob and secure the cable.

4