NordicTrack NTTL11513 Assembly, Extension Legs 88 remain in the Uprights, Handrail Bolts

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench , and wire cutters .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the treadmill or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt or foot pads, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the	1
Uprights (110) to the position shown.
Refer to the inset drawing. Insert one of the Extension
Legs (88) into the treadmill as shown. Make sure that			110
the Extension Leg is turned so the Thick Base Pad (90)
is on the bottom. Note: It may be helpful to tip the
Uprights (110) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same				110
way.
				88
				90
2. With the help of a second person, carefully tip the	2
Uprights (110) down as shown. Make sure that the
Extension Legs (88) remain in the Uprights.			90
Attach each Extension Leg (88) with two Base Screws		90
(86) and a Base Pad (75) as shown.
With the help of a second person, carefully tip the				90
Uprights (110) back to the vertical position.	110		110
Note: One replacement Base Pad (90) may be included.			88	86
If a Base Pad needs to be replaced, use the replacement	90	86		90
Base Pad.
	90
		88
3. Refer to drawing 3a. While another person holds the	3a
Handrails (89), thread Handrail Bolts (111) about 2-3
turns into the two holes in each Handrail. Then, remove		89
the Handrail Bolts.
Refer to drawing 3b. Pinch the tabs on the Grounding
Bracket (115) so that the tabs will fit into the indicated			111
hole in the left Upright (110). Then, insert the Grounding
Bracket into the hole as far as possible.	3b
		115
Note: It may be helpful to set the Handrails (89) on the			110
Uprights (110) and loosely thread a Handrail Bolt (111)			111
into the left Upright and the left Handrail. Tip the
Handrails, if necessary, to thread in the Bolt. Have an-
other person support the Handrails as you complete the
remaining steps.

6