15. | Locate the LEFT ACCESSORY TRAY (#11). Carefully slide the tray into the | 11 | 12 |
| top of the LEFT UPRIGHT (#1) as shown until fully seated. Secure the | ||
|
| ||
| accessory tray to the LEFT TOP MOUNTING PLATE (H) using four screws |
|
|
| (#21). Repeat the procedure for the RIGHT ACCESSORY TRAY (#12) and |
|
|
| RIGHT TOP MOUNTING PLATE (J). |
|
|
16. | Tighten all UPRIGHT BOLTS securely. |
|
|
17. | Replace the MOTOR COVER (E) and secure the MOTOR COVER to the |
|
|
| FRAME (C) using the four previously removed SCREWS (D). Tighten the | 21 |
|
| SCREWS securely. Do not |
| |
|
|
| |
18. | Replace the FRONT GRILL (B) and secure the FRONT GRILL to the |
|
|
| FRAME (C) using the four previously removed SCREWS (A). Tighten the |
| 2 |
| SCREWS securely. Do not | 1 |
|
19. Locate one SCREW GROMMET (#18). Insert the SCREW GROMMET into the square hole located above the top inside mounting bolt of the RIGHT UPRIGHT (#2). Repeat for the remaining SCREW GROMMET and LEFT UPRIGHT (#1)
20.Locate one LOWER UPRIGHT COVER (#10). Position the LOWER UPRIGHT COVER at the bottom notch of the RIGHT UPRIGHT (#2) making sure the top lip of the UPRIGHT COVER is engaged under the outside notch of the RIGHT UPRIGHT. Secure the UPRIGHT COVER to the RIGHT UPRIGHT using one SCREW (#16). Tighten the SCREW securely. Do not
|
| ||
and remaining UPRIGHT COVER. | 2 | 16 10 18 | |
21. Locate the UPRIGHT PLUGS (#25). Insert one UPRIGHT PLUG into each of | |||
|
the two access holes located on the lower outside of the LEFT and RIGHT UPRIGHTS (#1 & #2).
22. Locate and press the HANDLEBAR CAPS (#13) over the ends of the HANDLEBARS (#3). Be sure the HANDLEBAR CAPS are fully seated.
23. Using two SCREWS (#16) each, attach the two REAR FRAME END CAPS (#14) to the FRAME (C) as shown. Tighten the SCREWS securely. Do not
24.Install the WAX BAG. Follow the instructions included in the WAX BAG KIT.
25.Refer to the Operation Manual for power requirements, proper line cord routing, and other critical product information before connecting the treadmill to a power source.
14
C | 16 |
| |
| 14 |