5CONSOLE AND ACTIVITY ZONE OVERVIEW
A.Accessory Trays and Water Bottle Holders are located on either side of the display console.
B. Energy Saver On / Off: The Energy Saver mode is used to minimize the power being pulled from the wall when the treadmill is not in use. The treadmill will automatically go into Energy Saver mode after ending a workout. Press the ENERGY SAVER button to either “wake up” the treadmill or put it into the Energy Saver mode. Energy Saver can be turned off in the Settings menu. An indicator LED will flash while in Energy Saver mode.
C.Virtual Trainer: The USB port is used to upload
D.Reset: Use the RESET Button as a delete key when entering workout data. Press the Reset button 3 times to exit any workout.
E.Enter: Use this key when entering data during workout set up.
F.Navigation: Use this button for forward, back, up, and down navigation during workout or console set up as well as incline, time, and speed workout adjustments. While setting up a workout use the LEFT / RIGHT arrows to scroll through workout setup options, and then use the UP / DOWN arrows to adjust the values. During a workout, use the LEFT / RIGHT arrows to adjust the workout difficulty level or HR Target in HR Programs. Use the UP / DOWN arrows to adjust time.
G.Settings: Press this button to enter a menu where the treadmill settings can be adjusted.
H.Workout Selection: Select one of the following workouts by pressing the corresponding button: USB (Virtual Trainer), Manual, Random, Hill, Fat Burn, Cardio, or Fit Test and begin workout
I.Reading Rack: Users can place Kindles®, iPads®, books, magazines or other reading devices on the
J.iPod® Docking Station: Users can dock, control, and charge their iPods during workouts. (See K. iPod Controls). An extra iPod® pad was included with the treadmill. Set the pad behind smaller iPod players when they are docked. You may need to remove the protective case from your device to dock properly. A protective clip may be present on the iPod connector. Remove prior to docking.
14