Spirit XT800, XT200/XT600, XT 800, XT 600 owner manual Step

STEP 2

1.Mount the L&R Handle bars onto Handle bar mounting plates at the top of the upright tubes with 4pcs of 5/16” x 2” Button Head Socket Screw and 4pcs of curved washer. NOTE: The L&R handle bars are different. The Right handle bar has two wires and the switches on the handle bar say “Fast and Slow” while the Left handle bar switch says “Up and Down”.

STEP 3

1.Install the L & R inside console end caps onto the ends of the 1-1/4” X 2-3/8” console mounting tube. Ensure the end caps are oriented correctly and facing the correct direction (see diagram). Also ensure that the wiring is fed through the end caps.

2.Place the console onto the L & R mounting brackets at the top of the upright tubes. Then install and hand tighten the 2 pcs. of 5/16” x 2-3/4” Hex Head Screw and flat washers through the hole in the top of the 1-1/4” X 2-3/8” console mounting tube and the 2 pcs. Of 5/16” x 1-1/2” Button Head Socket Screw and flat washers through the hole in the front of the 1-1/4” X 2-3/8” console mounting tube.

3.Connect all of the connectors from the console to the mating connectors at the top of the upright tubes. There should be three connectors on the right side and one connector on the left side.

4.Install the outside pieces of the console end caps with 6pcs of 3.5mm x 25mm Phillips head Screw. (Be careful, don’t cut the wires.)

STEP 4

1.Tighten all the screws securely from the previous steps.

2.The mounting screws for the Upright covers are screwed into the base of the treadmill. You must remove these first. Install the 6pcs of 3.5mm x 25mm Phillips head Screw into the upright covers.

9 XT200. / XT 600 / XT 800