!!ATTENTION: IMPORTANT UNPACKING INSTRUCTIONS. PLEASE
READ BEFORE UNPACKING YOUR FOLDING TREADMILL!!
Serious injury could occur if this folding treadmill is not unpacked properly.
There is a Velcro strap installed around the treadmill base that prevents the treadmill from unfolding accidentally during shipping. If this strap is not removed properly the treadmill could spring open unexpectedly and cause injury if someone is standing near the treadmill when the strap is removed.
To ensure your personal safety during removal of the shipping strap please make sure the treadmill is positioned flat on the ground, in the orientation it would be in if you were using the treadmill. Do not turn the treadmill up on its side while removing the shipping strap. This could cause the treadmill’s folding mechanism to spring open. If the end of the Velcro strap (that you need to grab to remove it) happens to be under the treadmill deck, reach under the deck to grab it, but do not tilt the treadmill up to gain access to the strap end.
Assembly ( ET6 / ET8 )
STEP 1
Remove all parts from the carton.
Locate the left and right frame base covers. Insert six M5 Speed Nuts on the small plates. Install the cover and use six 5 x 16mm Screws to fasten.
STEP 2
Connect the lower Computer Cable with the middle Computer Cable.
STEP 3
Hand tighten Right and Left Uprights into the Frame Base with eight 5/16 x 1/2
Button Head Socket Bolts, by using the Combination M5 Allen Wrench & Phillips Head Screwdriver
STEP 4
Connect the middle Computer Cable with the upper Computer cable.
Connect the Speed Switch Cable with the upper Speed Cable from the console. Connect the Incline Switch Cable with the upper Incline Cable from the console.
STEP 5
Install the Console Support into the Right and Left Handrails with four 5/16 x 1/2 Button Head Socket Bolts by using the Combination M5 Allen Wrench & Screwdriver.
PLEASE LOCK DOWN ALL HARDWARE AFTER THE ACCESSSORIES HAVE BEEN ASSEMBLED.
8 | ET6 / ET8 / ET10 |