Assembly

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver . For help identifying the assembly hardware, see the drawings below. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 26 and 27. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled. To avoid damaging plastic parts, do not use power tools for assembly.

3/4” Screw (4)–4	Handrail Bolt (64)–6

Star Washer
(90)–10	Upright Bolt (72)–4
	Upright Bolt (72)–4

	1. Make sure that the power cord is unplugged.	1
		1
	With the help of a second person, raise the front
	of the treadmill and insert the crossbar on the
	Base (83) into the cutout in the cardboard stand
	as shown. Have the second person hold the
	treadmill to prevent it from moving forward
	or backward until assembly step 2 is com-
	pleted.
	WARNING: Serious injury
	may occur if the treadmill moves for-
	ward or backward and falls off the card-
	board stand. A second person must
	hold the treadmill until assembly step 2
	is completed to prevent the treadmill	83
	from moving, tipping, or falling.	83
	from moving, tipping, or falling.	Cardboard
		Cardboard
		Stand
		7