JVC UX-P7 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception

Continued

AM antenna

]]

Connecting Speakers

1	2
	3

ANTENNA

1

Vinyl-covered wire (not supplied)

Red Gray

AM EXT

AM LOOP

FM 75

COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

	RIGHT	LEFT		RIGHT	LEFT
			MAIN
			SPEAKERS
SUBWOOFERS
	SPEAKER			SPEAKER
	IMPEDANCE			IMPEDANCE	Blue
	MIN 6			MIN 6
	Black
	Speaker cords
			Speaker cords
Black	Blue		Black	Blue
	Red	Gray		Red	Gray
Right Speaker			Left Speaker

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to

red (+) and black (–) to black (–), gray (+) to gray (+) and blue (–) to blue (–).

• Remove the vinyl covering the wire by twisting it as shown in the diagram.

3Release the finger from the clamp.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –