ParaBody 625 manual Ring Cable, Rotary Cable, Cable Must be Routed the Same Wayit WAS Removed

607/608 FACTOR 625 D-RING RETRO KIT ASSEMBLY INSTRUCTIONS

STEP 1: D-RING'INSTALLATION

1.To assemble the newD-RINGto the FACTOR625, use the following steps:

¯Removeall the CABLESfrom the old D-RING.

¯Loosen, and removethe two (2) 1/4-20 NUTS,and the 1/4 IN. WASHERfrom the end of the

RING CABLE.

¯Slide one (1) VINYLCAPover the end of the new D-RING.

¯Removeand discard old D-RING,and replace with the new D-RING.

¯LOOSELYattach the 1/4 IN. WASHER,and the two (2) 1/4 IN. NUTSto the end of the D..RING CABLE. (POSITION THE 1/4-28 NUTS HALF WAYUP ON THE THREADSOF TIlE D-

RING CABLE UNTIL CABLE INSTALLATION IS COMPLETE. DO NOT TIGI-][TEN NUTS AT THIS TIME)

STEP: 2 CABLE INSTALLATION

NOTE: FOR EASE OF CABLE REPLACEMENTTHE D-RING END OF THE OLD CABLES MAYBE CUT OFF. IF THIS IS NOT POSSIBLE SOME PULLEYS WILL NEED TO BE LOOSENEDAND REMOVED TEMPORALLY IN ORDER TO REMOVE OLD CABLES.

To replace the ROTARYCABLE(6406001), or (depending on which RETROKIT being assembled) the LEGPRESS/ROTARYCABLE(6405701), see the drawing, and use the following steps:

¯Removethe SHOCKCORDfrom the BASEof the 625, then remove it from the end of the old

ROTARY CABLE.

¯Removeand discard the old ROTARYCABLE,and replace it with the new ROTARYCABLE.

(THE CABLE MUST BE ROUTED THE SAME WAYIT WAS REMOVED).

¯Run the ROTARYCABLEthrough the hole of the D-RINGshown in (DETAILA )on drawing, and attach one (1) D-RINGCABLECLIP around the ball end of the ROTARYCABLE.

¯Attach one (1) SHOCKCORDto the D-RINGCABLECLIP on the end of the ROTARYCABLE as shown in (DETAILA).

¯Route the SHOCKCORDthe same way that it was removed. Attach one (I) SWIVELto the end the SHOCKCORD,and slide the swivel over the BARon the BASEas shown in (VIEWB-B). Replace the SHOCKCORDto its original position on the BAR

¯IMPORTANT: MAKESURE THAT THE D-RING CABLE CLIP IS POSITIONED VERTICALLY ABOVE THE D-RING.