ParaBody 837101 manual Weight Stack Attachment Assembly Instructions, Pulley

837101 WEIGHT STACK ATTACHMENT ASSEMBLY INSTRUCTIONS

USING EXTREMECAREslide the WEIGHTPLATES down over the GUIDE RODS onto the WEIGHT STACK CUSHIONS as shown. (MAKE SURE THAT THE KEY HOLES OF THE

WEIGHT PLATES ARE ALL FACING THE SAME WAY) Slide the HEAD PLATE ASSEMBLY down over the GUIDERODSonto the WEIGHTSTACKas shown.

I0.	Tilt the GUIDERODSback	up underneath	the PULLEYHOUSINGWELDMENTand insert			the	3/8 X
	2 IN. NYLONBOLTSthrough the PULLEYHOUSINGWELDMENTand			into	the ends of the		GUIDE
	RODSas shown in (VIEWB)
11.	.Loosen and remove the top	PULLEYfrom the	PULLEYBLOCKand replace	it	wi.th the 4-I/2	X 1 IN.
	PULLEY.

12..SECURELYassemble the remaining PULLEYfrom the BOOMWELDMENT,and the swapped PULLEYof the PULLEY BLOCKto the PULLEY HOUSINGWELDMENTas shown in (VIEW B).

13.HIGH PULLEY CABLE ROUTING ASSEMBLY (SEE CABLE ROUTING DL4GRAM):

Ao

Uo

Route the end of the CABLEunder, and around the 4-1/2 X 1 IN. PULLEYof the PULLEY BLOCK,and back up through the BOOMWELDMENTtothe large hole of the PULLEY HOUSING WELDMENT.

Route the CABLEthrough the hole and over and around the two PULLF,YSinthe PULLEY HOUSINGWELDMENTRun. the cable down through the large hole above the WEIGHT STACKand do~vn to the WEIGHTSTACKSHAFTof the HEADPLATE.

Co Thread the end of the CABLEinto the end of the WEIGHTSTACKSHAFT.

Insert the 3 X 2 IN. ENDCAPSinto the ends of the PULLEYHOUSINGWELDMENTas shown in (VIEWB).

14.Re:attach LA T BAR WELDMENTto the HIGH PULLEYCABLE.

15.Attach the WEIGHTSTACKLABELSto the WEIGHTSTACKas shown in (DETAIL C).

16.To select WEIGHT,rotate the WEIGHTSTACKSELECTORPIN clock wise 90 degrees, insert into the slot of the desired WEIGHTPLATE,and rotate the PIN back down.

4

12/01/95