ParaBody 701 manual Level

701 FACTOR525 PEC DEC ATT. ASSEMBLYINSTRUCTIONS (LEVEL

The D-RINGCABLECLIP on the end of the LINKCABLEshould rcstjust above the D-RING.If the LINKCABLEseems to be pulling on the D-RINGor is resting too far above the D-RING,adjust it by raising or lowering the two (2) 1/4-25 lN. NUTSthat attaches the LINKCABLEto the PULLEY BRACKETWhen.the correct height is obtained SECURELYtighten the two (2) 1/4-28 NUTStogether around the PULLEYBRACKET.

To adjust the pre-stretch on the PECDECAILVIS:

Pull up on the COT'fERLESSHITCHPIN.

Swivel the ARMforward or backward.

Let the PIN drop down into one ofthe two holes in the PECARMADVANCES.

Or let the PIN drop behind the PECARMADVANCES.

NOTE: IF ASSEMBLING THE LEG PRESS ATTACHMENTNEXT, STOP HERE AND REFER TO THOSE ASSEMBLY INSTRUCTIONS. IF ONLY ASSEMBLING TIIE PEC DEC ATTACHMENT TO BASE UNIT, ~CONTINUE ON WITH THESE ASSEMBLYINSTRUCTIONS.

lO.	Wrap the SHROUDaround the CABLESthat t-oute to the	D-RING,and assemble the	SHROUDto
	BOTHSIDESof the MIDDLEU,'~PRIGHTas shown in (VIEWF-F) on drawing, using the fourteen (14)
	SHROUD FASTENERS.
	THIS CONCLUDESTHE ASSE~,IBLY	OF (LEVEL 2),	AND

THE ASSEMBLY OF THE PEC DEC ATTACHMENT FOR

THE FACTOR 525 BASE UNIT.