705101 REGGIE WHITE ALL PRO GYM ASSEMBLY INSTRUCTIONS
Slide two (2) 2
Insert ali ENDCAPSinto the WELDMENTSasshown on drawing.
SECURELYassemble the UPRIGHTto the BASEas shown on drawing.
BEFORE TIGHTENING CONNECTIONMAKE SURE THAT THE UPRIGHT FRAME IS SQUARETO THE BASE.
MAKESURE BOLTS GO THROUGHTHE BASE FIRST AND THAT LOWHEIGHT LOCKNUTS ARE USE]).)
Attach the SEATSUPPORTto the BASEand UPRIGHTas shown in drawing.
Assemble PULLEYSto the inside of the TOPBOOMas shown in DETAILB and string CABLE 6571001 as shown in CABLEROUTINGDIAGRAM.
Attach the TOP BOOMto the UPRIGHT. (MAKESURE CABLERUNSOVERTOP OF BOLTS)
¯Insert two (2) WEIGHTPLATEBUSHINGSinto each WEIGHTPLATEas shown in DETAIL Insert GUIDERODSand WEIGHTSTACKCUSHIONSinto BASE.
9.CAREFULLYslide fifteen (15) WEIGHTPLATESonto the GUIDERODS.
]0. Assemble the HEADPLATEand WEIGHTSTACKSHAFTand slide it onto the GUIDERODS.
Attach GUIDERODSto the TOP BOOMusing two (2) NYLONBOLTS.
]2. Attach the LEG EXTENSIONand ROLLERPAl) SWIVELto the SEATSUPPORTas shown in
DETAILC.
]3.Attach the SEAT and BACKPADSto the SEAT SUPPORTand UPRIGHT.
14.Attach two (2) RUBBERBUMPERSto the SEATSUPPORTas shown in DETAIL
]5. To attach PRESSARMASSEMBLYto fl~e BASE,follow assembly drawing and these steps:
(NOTE: Make sure that the CROSSBRACEis resting on the RUBBERBUMPERof the SEAT SUPPORTand positioned so that the bottomtab is closer to the rear of the gym.)
Attach the other PRESSARMto the CROSSBRACEand the SHAFT.
IN THISORDER,press the bottom of the PRESSARMStogether against the locking collars and tighten both SETSCREWS,then center CROSSBRACEand tighten bolts.
16.AT THIS TIME TIGHTEN ALL LOOSEFRAMECONNECTIONSMADETO THIS POINT.
17.Assemble two (2) PULLEYSto the
18.LOOSELYassemble all remaining PULLEYSto the gymas shown on drawing.
19.String CABLE6575601 as shown in CABLEROUTINGDIAGRAM,looping it with the top cable using
3
] 2/4/95