ParaBody 200 manual KX-l Hardware, SIll

KX-l HARDWARE	•	2
	•	MAIN UNIT AND

MAIN UNIT AND ACCESSORIES- ASSEMBLY INSTRUCTIONS

STAND A~SORIES

WEIGHT SELECTOR KEY

®: SNAP HOOK

@h /2" EYEBOLT

..... @6" STRIPPER BOW

® .. I, Of PIN

- lROlT -

Connect base assenbly (5) to foot plate (7) as shown with

1 four: 3/S" XZ-3/4"bolts (40), 3/S" acorn nuts (4Z), and 3/S" washers.

-TOP YUW-

Hake sure the guiderods are in center of weight bushing

3 holes before tigbtening tben down. Also, nake sure guiderods are perpendicular to the base by conparing it's parallel with another reliable vertical in the roon.

Connect eyebolt (31) with l/Z" nut, (31), 1/2" lonimber (33), 1/2' washer (3Z), and add-on bracket (Z3) as abown

and tigbten to diBension shown. Hipe guiderods down again - dinension sbown. Hipe guiderods down again with Clear Guard

5 as described in step I 2. 110 get Balilu, life and lininuB friction, clean rods with Clear Guard occasionally).

k~

-llf;

Sec~re both !uiderods (9) to base asselbly (5) with four: 3/S I Z-l/Zbolts (ZS), 3/S" lockwashers (30) 3/S" nuts

2 (Z9), ~s sbown and torque to finger tight. Nip~ both rods do~n wlth Clear Guard (silicone) as shown. Slip on a pair of gUlderod cusbions (Z5) and the !irst weight. (Z50-lb wt)

n

(I

.0

c

C

6C

~

- nm lIIII-";

(m SIll)'

Asseable sten assenbly with top weigbt and roll pin as

4 as shown. Slip staok plates on guiderod (keeping consecutive order and sten assenbly with "weight key storage hole" in front).

A. -

Connect vertical lain fra-Ie (4) -tobaae asmbly as sboin. fasten at 'A: uaing tlO: 7/16" I Z' hoita (35), 7/16' lonimhers (37), 7/16" nnts (38) and four 7/16' lashers,

6	flnger ti!bt only. rasten Tusing tlO: 1/2" I 3" bolts ;;
	(39),	1/2 lonimbers	(33), and liZ" nuta (34).			Tighten-'
	dOln	mOBEL1!	-	-	--	"." ~-.~ •.