1.LOOSELY assemble the CROSS MEMBER (1) onto the FRONT FRAME (2) and REAR FRAME (3) using four M10 X 135mm BOLTS (4), eight 3/8" SAE WASHERS (5), and four M10 NYLOX NUTS (6) as shown.
2.LOOSELY assemble the FRONT FRAME (2) and REAR FRAME (3) using two M10 X 25mm BOLTS (7), four 3/8" SAE WASHERS (5), and two M10 NYLOX NUTS (6) as shown.
3.Tighten all BOLTS and NUTS securely.
4.Install 1" HOLE PLUGS (8) into all open bolt holes.