NOTE: Some components have been removed from the illustration for clarity.
17.Assemble one M10 HEX JAM NUT (35) onto one end of the CABLE (36) approximately 1/2”. Assemble the ROD END BEARING (37) to the same end of the CABLE until it meets the M10 HEX JAM NUT. Tighten the M10 HEX JAM NUT securely.
18.Loosely assemble the ROD END BEARING (37) of the CABLE (36) to the WORKARM (18) using one M10 X 40mm BOLT (38), SPACER (39), 3/8" SAE WASHER (5) and M10 NYLOCK NUT (6) .
19.Route the CABLE (36) over the CAM GUARD (28) and around the OUT- PUT CAM ASSEMBLY (B). Insert the remaining end of the CABLE through the inner hole of the OUTPUT CAM ASSEMBLY.
Insert the CABLE RETAINING PLATE (40) over the end of the CABLE. Install two M8 HEX JAM NUTS (42) to the end of the CABLE.
Tighten the M8 HEX JAM NUTS until the WORK ARM begins to move and all push pins still move in and out freely. Be sure the HEX JAM NUTS are tight against each other.
20.Attach the OUTPUT CAM COVER PLATE (41) to the OUTPUT CAM ASSEMBLY (B) using three M10 X 45mm BOLTS (42) and three 3/8" SAE WASHERS (5).
21.Place the unit in the inteded place for use and check stability. If the unit is not stable, the FEET (D) can be adjusted by inserting or removing sup- plied SHIMS (43).
To add or remove SHIMS, loosen the LEVELING FOOT BOLT (E) and NUT (6) until the desired SHIM(S) can be inserted or removed. Lightly tighten the BOLT and NUT. Do not
22.Install HOLE PLUGS in all open bolt holes.