16 |
|
|
|
| 1 |
|
| 10 |
| 7 | 6 |
|
| |
|
| 4 |
8 |
| 5 |
FIGURE 4 |
|
|
STEP 4:
•Hook the SMITH BAR (7) onto slots of the BAR SUPPORT RACKS (8).
•Slide one GUIDE ROD (10) through the upper hole in the UPRIGHT (1 & 16) and proceed to slide one 1” SHAFT COLLAR (6) over the bottom of the GUIDE ROD (10) as shown in FIGURE 4.
•CAREFULLY lower the GUIDE ROD (10) through the HOUSING (4) on the SMITH BAR (7). (NOTE: Allow the GUIDE
RODS (10) to push the plastic insert out the bottom of the HOUSINGS (4). Discard these inserts.)
•CAREFULLY slide one BAR STOP (5) over the end of the GUIDE ROD (10). Hook BAR STOP (5) into the slots of BAR SUPPORT RACKS (8) as shown.
•Insert the GUIDE ROD (10) into the bottom hole of the UPRIGHT (1 & 16). Repeat this step on the other side.
7