Gold's Gym XR15, GGBE14821 manual Lubricate

5.Press three 45mm Square Inner Caps (26) into the Leg Lever (6). Press a 25mm Round Inner Cap (47) into the Weight Tube (15).

Attach the Weight Tube (15) to the Leg Lever (6) with an M8 x 58mm Bolt (33), two M8 Washers (34), a Spacer (29), and an M8 Nylon Locknut

(35).Press the 25mm Round Angled Cap (25) onto the end of the Weight Tube.

Lubricate an M10 x 68mm Bolt (41) with grease. Attach the Leg Lever (6) to the Front Leg (4) with the Bolt and an M10 Nylon Locknut (37). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.

6.Press four 25mm Square Inner Caps (28) into the ends of the Backrest Frames (10).

Attach the Backrest Frames (10) to the Adjustment Bracket (11) with four M10 x 45mm Bolts (43), four M10 Washers (49), and four M10 Nylon Locknuts (37). Make sure the indicated holes are closer to the bottom of the Frames. Do not tighten the Locknuts yet.

7.Attach the Backrest (14) to the Backrest Frames

(10)with four M6 x 38mm Bolts (46) and four M6 Washers (45). Do not tighten the Bolts yet.

8.Lubricate the M10 x 156mm Bolt (39) with grease. Attach the Backrest Frames (10) to the Bench Frame (1) with the Bolt, two M10 Washers (49), and an M10 Nylon Locknut (37). Do not overtighten the Locknut; the Backrest Frames must be able to pivot easily.

Insert the Adjustment Bracket (11) into the slot in the Bench Frame (1). Insert the Backrest Pin (38) into the Bench Frame and a hole in the Adjustment Bracket.

Attach the tether on the Backrest Pin (38) to the bottom of the Bench Frame (1) with an M4 x 16mm Screw (36).

Tighten the four M10 Nylon Locknuts (37) and four M6 x 38mm Bolts (46) used in steps 6 and 7.

5
		26	37
		6
26		34	25
				41,
	33	29	35	Lubricate
15				4
			34
		26
47
6
				28
43	49	Hole		10
			37
49
	37			Hole
28	11			49
			49	43
		28
7
		14
				45
10			46
45
46		45
8
		10
39			38	11
	49			1
			49
			37	36

7