Healthrider HREX04981 manual Maintenance and Troubleshooting, HOW to Select Kilometers or Miles

6Turn off the power

To turn off the power, simply wait for about six minutes. If the pedals

are not moved and

the console buttons are not pressed for six min- utes, the power will turn off automatically.

HOW TO SELECT KILOMETERS OR MILES

To change the unit of measure- ment, see step 5 on page 7 and remove the Handlebar. Next, remove the four indicated screws from the console. Lift the console a few inches and turn it over; be careful not to pull on the wires.

Switch

Screws

The console can display distance and speed in either kilometers or miles. If a ÒKPHÓ appears in the display, distance and speed will be shown in kilometers; if a ÒKPHÓ does not appear, distance and speed will be shown in miles.

Locate the small switch on the back of the console. Slide the switch up or down to change the unit of mea- surement. Reattach the console with the four screws; be careful not to pinch any of the wires.

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the recumbent cycle regularly. The recumbent cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the con- sole out of direct sunlight.

BATTERY REPLACEMENT

If the console does not function properly, the batteries should be replaced. To replace the batteries, the handlebar must be removed. See assembly step 4 on page 7 to remove the handlebar. Next, refer to assembly step 5 to install batteries.

PULSE SENSOR TROUBLE-SHOOTING

¥Avoid moving your hands while using the pulse sen- sor. Excessive movement may interfere with heart rate readings.

¥If your heart rate is not shown when the pulse sen- sor is used, press the resistance Ð button to reset the pulse sensor.

¥Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.

¥For the most accurate heart rate reading, hold the metal contacts for about 15 seconds.

¥For optimal performance of the pulse sensor, keep the metal contacts clean. The contacts can be cleaned with a soft clothÑnever use alcohol, abrasives, or chemicals.

12