4.While another person holds the Handlebar (13) in the position shown, connect the two console wires to the two Pulse Wires (96).
Push the wires and connectors into the Handlebar (13).
5.With the help of another person, loosely attach the right side of the Handlebar (13) to the Upright (3) with two 3/8Ó x 1 1/4Ó Bolts (92), two 3/8Ó Washers (94), and two Spacers (93). Make sure that the Spacers are positioned between the Handlebar and the console plate. Be careful to avoid pinching the wires.
Attach the left side of the Handlebar (13) in the same manner.
Firmly tighten all four 3/8Ó x 1 1/4Ó Bolts (92).
6.Rotate the Right Pedal Leg (6) in the direction shown.
See the inset drawing. Identify the Right Pedal (23); the Right Pedal has an opening on the indicated side. Slide the Right Pedal onto the Right Pedal Leg (6) as shown. Make sure that the plastic posts are completely inserted into the holes in the Right Pedal Leg.
Place three #10 Washers (89) on three #8 x 1 1/2Ó Screws (88). Insert the three Screws about halfway into the Right Pedal Leg (6) and thread the Screws into the plastic posts on the Right Pedal (23). Using a phillips screwdriver, tighten the three Screws into the plastic posts. Do not overtighten the Screws or the plastic posts may break.
Attach the Left Pedal (not shown) in the same way.
4 |
|
|
|
|
|
|
| 96 |
|
13 | Console |
|
| |
Wire |
|
| ||
|
|
| ||
Console |
|
|
|
|
Wire |
|
|
|
|
96 |
|
|
|
|
|
|
| 3 |
|
5 |
|
|
|
|
|
|
| 13 |
|
| 92 | 94 |
|
|
| 93 |
|
| |
|
|
| 93 |
|
93 |
|
| Console | |
|
|
| 94 | Plate |
|
|
| 92 | |
94 |
|
|
| |
| 93 |
| 3 |
|
| 94 |
|
| |
92 |
|
|
| |
|
|
|
| |
6 |
|
|
|
|
|
| 6 |
| 88 |
|
| Plastic |
| 89 |
|
| Posts |
|
|
|
| Opening |
| |
|
|
| 23 |
|
|
| 6 |
|
|
7.Make sure that all parts of the elliptical crosstrainer are properly tightened. To protect the floor or carpet from damage, place a mat under the elliptical crosstrainer.
5