Cateye CC-HB1OO instruction manual Button Functions

E

MODE START/STOP

Fig.1

Left Button

SUB DISPLAY

T

D

Button Functions

Left Button (Mode Button)

With each press of this button, the mode symbol shifts as shown in Fig. 2.

*If this button is held for about 2 seconds, symbol (12-hour clock) is displayed. If pressed for over 4 seconds, heart rate display is changed from the current heart rate to AP

(average heart rate) or from AP to the current heart rate.

Right Button (Start/Stop Button)

With each press, this button starts or stops measuring of trip distance(D), elapsed time(T), average speed(A), average heart rate(AP), and calorie consumption(CAL). During opera- tion, the speed scale symbol flashes.

*In the Auto (automatic start/stop) function [when symbol is on], this button does not work (refer to page 9).

A

HR

Set Button (on the back)

This button is used for the following operations:

For switching on/off the Auto (automatic start/stop) function

O

AP

Hold down

M2 sec. 4 sec.

CAL

Fig.2	HEART RATE DISPLAY
T ----------	Elapsed Time
D ----------	Trip Distance
A ----------	Average Speed
O ----------	Total Distance
M ---------	Maximum Speed
CAL ------	Calorie Consumption
-------	12-Hour Clock
HR --------	Heart Rate
AP --------	Average Heart Rate

------------------------------------------------------	press this button in T, D or A mode
For setting the wheel circumference ------	press this button in O mode (but in stop state)
For setting clock time --------------------------	press this button in	display (but in stop state)
For setting the upper/lower heart rate limit
------------------------------------------------------	press this button in M mode (but in stop state)

AC Button (on the back)

This button erases all the data stored in memory. Don't press this button except after

replacing the battery or when irregular display occurs. Since all the memories are cleared off, set the necessary data again according to "Main Unit Preparation" (refer to page 7).

Reset

When the left and right buttons are pressed simultaneously, trip distance, elapsed time, aver- age speed, maximum speed, average heart rate and calorie consumption returns to zero.

*If this operation is executed in O display, it doesn't reset the data; instead, the wheel circumference stored in memory is displayed.

6