JVC CA-MXSK3, MX-SK3 Listening to FM and AM Broadcasts, Tuning in a Station, Presetting Stations

2 Select a preset number. On the unit:

Press 4 or ¢.

On the remote control: Press the number

buttons.

The tuned station in step 1 is stored in the preset number selected in step 3.

• Storing a new station on a used number erases the previously stored one.

When you unplug the AC power cord or if a power

failure occurs

The preset stations will be erased in a few days. If this happens, preset the stations again.

Tuning in a Preset Station

English

Listening to FM and AM Broadcasts

Tuning in a Station			On the unit ONLY:
1 Press FM/AM.			1	Tune in the station you want to preset.
The unit automatically turns on and tunes in				• See “Tuning in a Station.”
			2
the previously tuned station (either FM or				Press SET.
AM).
• Each time you press the button, the band
alternates between FM and AM.
2 Start searching for stations.			3
On the unit:				Press 4 or ¢ to select a preset number.
Press and hold
TUNING +/ ¡ or
TUNING 1 /– for
more than 1 second.
On the remote control:			4
Press and hold ¢	PREV.	NEXT		Press SET again.

(NEXT ¡) or 4 (PREV. 1) for more than 1 second.

The unit starts searching for stations and stops when a station of sufficient signal strength is tuned in.

• If a program is broadcasted in stereo, the ST (stereo) indicator lights up.

On the unit:

To stop searching, press TUNING +/ ¡ or TUNING 1 /– .

When you press TUNING +/ ¡ or TUNING 1 /– briefly and repeatedly

The frequency changes step by step.

To change the FM reception mode	MPX /
When an FM stereo broadcast is hard to receive or	FM MODE	1 Press FM/AM.
noisy, press FM MODE on the remote control so
that the MONO indicator lights up on the display.		The unit automatically turns on and tunes
		in the previously tuned station (either FM
Reception improves.
		or AM).
To restore the stereo effect, press FM MODE again so that
		• Each time you press the button, the band alternates
the MONO indicator goes off. In this stereo mode, you can		between FM and AM.
hear stereo sounds when a program is broadcasted.

Presetting Stations

You can preset 30 FM and 15 AM stations.

In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.

•There is a time limit in performing the following steps. If the setting is cancelled before you finish, start from step 1 again.

Ex.: For preset number 5, press 5. For preset number 15, press

+10, then 5. For preset number 20, press

+10, then 10.

For preset number 25, press +10, +10, then 5.

For preset number 30, press +10, +10, then 10.

– 12 –