Raise Center of Tent | Brace pole | |
3 – Assemble center | ||
| ||
poles (red sticker, longer poles). | Curved | |
Pole should be initially adjusted to the | poles in | |
inner most hole “A”. (illus. 7) | pole sleeve | |
– Insert square end of brace poles into |
| |
curved roof poles and raise tent upright. |
| |
(illus. 5, 6, 7) |
| |
– Brace poles should attach to squeeze |
| |
pins at bottom of tent. (illus 8) |
| |
– Repeat for brace poles at front |
| |
of screen area. |
|
illus. 6 When attaching the brace poles to the curved poles make sure that the brace poles naturally point straight down.
illus. 5
Shown with both center brace poles in
position and curved poles through
center pole 
sleeves.
illus. 7 
Poles should be initially adjusted to the inner most hole “A”.
4 Raise Ends of Tent
– Assemble end (blue sticker, round ends)
– Insert (blue sticker) brace poles into end roof assemblies. MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the center of the tent. (illus. 9)
– Brace poles should attach to squeeze pins at bottom of tent. (illus. 8)
– Adjust poles to accomodate for terrain.
Center brace poles
Rainfly hooks to brace poles
illus. 8
Insert squeeze pin into pole
– Drape rainfly over tent, covering the center and end poles sleeves. Attach “S” hooks on rainfly into holes in brace poles. (illus. 9)
illus. 9 Tent shown completely
Things You Should Know
•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.
•Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.
•Do not leave your tent
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
PRINTED IN SRI LANKA Rev. 7/04