STITCH LINE
tent setup instructions
MODEL 2000010194 Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.
•Secure with all stakes and guylines provided to prevent property
damage or personal injury.
• For best results in windy conditions, position narrow end of tent |
|
into the wind. |
|
• Do not drop tent. | Fig. 6 |
• Do not bounce tent bag on its end to remove tent, as these | |
actions may damage the frame. |
|
•THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the tent frame.
Description | Repair Kit | Description | Repair Kit |
|
| ||
Plastic Clip 16 mm | 5010000845 | Plastic Corner Joint | 5010000851 |
|
| ||
Plastic Clip 20 mm | 5010000846 | Fabric Joint Cover | 5010000856 |
|
| ||
Fabric Repair Kit | 5010000852 |
|
|
|
| ||
1 | Extend the Tent Frame |
| 3 | Fig. 5 | |||
| Verify Connections | ||||||
• Stand the tent upright with the hub assembly at the | |||||||
between Tent and | |||||||
top. (Fig. 1) |
|
|
| ||||
| • Unfold the arms of the tent downward until they lay flat on | Frame Poles | |||||
| the ground. (Fig. 2) |
|
|
| |||
|
| • Verify the clips along the edges of the tent are properly |
|
| attached to the frame poles. (Fig. 7 and 8) |
2 | Fig. 1 | Fig. 2 |
Raise the Tent |
| |
• Unfold the arm joints located at each of the tent corners. | ||
The tent will raise as the leg poles are extended. |
| |
(Fig. 3 and 4) |
| |
•Extend each of the telescoping leg poles until they snap
into place. (Fig. 5 and 6) | Fig. 7 |
|
Clip
Fig. 4
Pole
Fig. 8
Fig. 3 | (continued on other side) |