Coleman 2000010387 manual Verify Connections, Between Tent, Frame Poles, Raise the Tent

STITCH LINE

tent setup instructions

MODEL 2000010387 Before you begin

• Read all instructions before set up.

• Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

• Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.

•Secure with all stakes and guylines provided to prevent property

damage or personal injury.

• For best results in windy conditions, position narrow end of tent
into the wind.
• Do not drop tent.						Fig. 6
• Do not bounce tent bag on its end to remove tent, as these
actions may damage the frame.
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
• Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
tent frame.
Description		Repair Kit	Description	Repair Kit
Plastic Clip 16 mm		5010000845	Plastic Corner Joint	5010000851
Plastic Clip 20 mm		5010000846	Fabric Joint Cover	5010000856
Fabric Repair Kit		5010000852				Fig. 5
1					3
	Extend the Tent Frame					Verify Connections
	top. (Fig. 1)					between Tent and
	• Stand the tent upright with the hub assembly at the					Frame Poles
	the ground. (Fig. 2)
	• Unfold the arms of the tent downward until they lay flat on

		• Verify the clips along the edges of the tent are properly
		attached to the frame poles. (Fig. 7 and 8)
2	Fig. 1	Fig. 2
	Raise the Tent
	• Unfold the arm joints located at each of the tent corners.
	The tent will raise as the leg poles are extended.
	(Fig. 3 and 4)

• Extend each of the telescoping leg poles until they snap	Fig. 7
into place. (Fig. 5 and 6)

Clip

Fig. 4

Pole

Fig. 8

Fig. 3 (continued on other side)