Coleman 2000001594 manual Things You Should Know, Cooler Access, To Store

Page 2

To Attach Rainfly continued

3.Insert end of each black Rainfly Pole into pin on either side of front door. (Fig. 10 & 10A)

4.Go to opposite end of Rainfly Pole and gradually apply pressure to form an arch. Insert the pin into pole end at other side of the door. (Fig. 10 & 10A)

5.Locate all hook & loop fasteners on underside of Rainfly and wrap around black and grey poles to secure. (Fig. 10B)

6.Stretch elastic straps and hook clip on each to the metal loops at the front and back of the tent. (Fig. 10C)

7.Extend out vestibule flaps and secure with metal stakes through the loops in the web straps (Fig. 10 & 5D)

8.Stretch guylines until taut, then secure with stakes. (Fig. 10 & 10E)

10B10A

10C

 

Fig. 10

Guylines

 

10E

10D

 

Electrical Cord Access

Fig. 16

1.Unzip the access panel in the lower left corner of tent and bring in an electrical cord.

NOTE: Use only UL approved cords rated for outdoor usage. (Fig. 16)

Cooler Access

 

The smaller zippered opening at the side of tent is

 

designed for added ventilation and easy access to

 

your beverage cooler.

 

1. To use as a vent, unzip flap to expose screen.

Fig. 17

2.To use as a cooler access, unzip other flap to

make an avenue to bring beverages into tent. (Fig. 17)

To Store

1.All poles and stakes must be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the tent fabric and its coating resulting in leaks or loss of flame-resistant properties.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

Stakes should be removed by pulling on the stake itself. NEVER PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.

Tent poles should not be left telescoped together during storage.

Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

STITCH LINE

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

© 2008 The Coleman Company, Inc.

Coleman®, , andare registered trademarks and MontanaTM is a trademark of

The Coleman Company, Inc.

4010004002 (20081030)

Image 2
Contents Before you begin To Set Up TentPole Descriptions Hinged, Rigid DoorTo Store Cooler AccessThings You Should Know