TENT SETUP INSTRUCTIONS
STITCH LINE
Before you begin
t Read all instructions before set up.
t Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
t Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.
t Secure with all stakes and guylines provided to prevent property damage or personal injury.
t For best results in windy conditions, position narrow end of tent into the wind.
t Enlist the help of at least one other person to assist you when it is time to assemble the tent.
Pole Descriptions
No. | Description | Qty. | Pole | Pole |
|
|
| Repair Kit | Replacement Kit |
1 | Main Body Pole, black, long | 2 | 5010000541 | 5010000547 |
2 | Ridge Pole, black, short | 1 | 5010000541 | 5010000547 |
|
|
|
|
|
1Layout & Positioning of Tent and Poles
t Layout and position the tent with door facing desired direction. (Fig. 1)
t Stake down tent corners first through the stake rings. (Fig. 2) t Keep the floor taut.
t Stake down the remainder of the stake rings.
t Assemble all poles by unfolding and interlocking the shock- corded pole sections.
t Insert the body poles into the pole sleeves.
Pole |
Sleeve |
1 |
Fig. 1
Tent
Stake
Stake Ring
Fig. 2
MODEL 2000007828
2Connect Poles to Tent
t Insert one pin into one end of the pole. (Fig. 3 and 4)
t Go to opposite end of pole and carefully insert the pin into the other pole end. (Fig. 4)
t Repeat for all poles.
Pole Clip
Fig. 3
Pole
Pin
Fig. 5
Fig. 4
3Attach Tent to Body Poles Using Clips
t Attach clips along the edges of tent to body poles. (Fig. 5) t Make any adjustments to the tent stakes, if needed.
4Attach Rainfly
t Attach top ridge pole to underside of rainfly with straps and insert the tips of the top ridge pole into the pockets on underside of rainfly. (Fig. 6 & 7)
t Drape rainfly over tent. (Fig. 8)
t Connect the elastic loops with “S” hooks, (found at the rainfly corners) to the rings found at the tent corners. (Fig. 9)
t Secure rainfly with straps located on the underside of rainfly. (Fig. 10)
t Attach and stake out elastic cord at ground vent and guylines. (Fig. 8)
HINT: During setup, keep door zipped to keep proper tension on fabric.
(continued on other side)