® | INSTANT SHELTER MODEL 2000002251 |
Before you begin
Read all instructions before set up.
•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your shelter.
WARNING: Keep clear of overhead power lines.
• Do not set up your shelter under trees because of potential |
lightning strikes or falling tree limbs in inclement weather. |
• Secure with all stakes and guylines provided to prevent property |
damage or personal injury. |
• For best results in windy conditions, position narrow end of |
shelter into the wind. |
• Do not drop shelter bag or pole. |
• Do not bounce shelter bag on its end to remove shelter, as these |
4.Secure sides of shelter top to frame with large, rectangular, hook & loop fasteners provided (2 on each side) (Fig. 4). The shelter top has been designed to have a tight fit over the frame.
5.Secure all remaining hook & loop fasteners, located on underside of shelter top, to shelter frame. (Fig. 5)
Fig. 4
Fig. 5
STITCH LINE
actions may damage the |
• THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF |
TWO PEOPLE TO ASSEMBLE. |
• Under no circumstances should this product be used to cover |
automobiles, marine products or similar items. |
Replacement Parts List
Description | Part Number |
Shelter Top | 5010000666 |
Screen House | 5010000667 |
Sun Wall | 5010000668 |
Extend the Shelter Frame
1.Select a smooth, level site for your shelter.
2.With two persons standing at diagonal corners of the struc- ture, grab the leg, and pull out to unfold frame. (Fig. 1) NOTE: Do not unfold frame completely. This will allow easier fit for draping shelter top over frame.
Fig. 1
Set Up the Shelter
1.Drape shelter top over frame. (Fig. 2)
2.Attach hook & loop fasteners, located on corners of shelter top, to four corners of frame post. (Fig. 2A)
Shelter Top | Fig. 2 |
2A
Shelter
Post
Cover
Adjust the Height
1. Adjust desired height by sliding post upward until push button locks into place. Raise each post one notch at a time, making sure all four posts are level before proceeding to the next notch. (Fig. 6 & 7)
NOTE: If installing the screen house panels to your shelter, skip the following
steps and proceed to “Install the Screen House”on the back page.
Stake the Shelter
1.Secure shelter by driving nail stakes through the holes located on the metal base of each frame post. (Fig. 8)
2.Stretch elastic strap on shelter post cover; then insert metal hook into hole on post. Repeat for remaining three posts. (Fig. 9)
3.If shelter is set at shorter heights, secure
post covers with metal stake through metal grommet on each. (Fig. 10)
If shelter is set at maximum height, secure post covers with metal stake through web strap on end of each. (Fig. 11)
|
|
|
|
|
|
|
|
| Fig. 9 |
|
| Fig. 10 |
|
| Fig. 11 |
|
|
|
|
|
|
|
|
Secure the Guylines
1.To secure guylines, find the guyline plastic slider and look for the portion, forming a loop (works just like a slip knot!). Extend guylines to ground until taut; then stake through the loops to secure. (Fig. 12, 13, & 14).
Fig. 12
Shelter Top
3.After fitting each corner of shelter top to frame, pull up sliding mold located on upper portion of leg until push button snaps into place (Fig 3 & 3A).
This will ensure fame is fully extended.
Fig. 3
Push
Button
3A
Fig. 13
Shelter Post
Cover
Fig. 14
(See other side for installing the screen house)