Ozark Trail owner manual Assembly Instructions WMT-1390S-1

ASSEMBLY INSTRUCTIONS: WMT-1390S-1

IMPORTANT: WE ADVISE YOU TO ASSEMBLE THE TENT ONCE BEFORE GOING CAMPING TO ASSURE THAT ALL PARTS ARE PRESENT AND TO BECOME FAMILIAR WITH THE ASSEMBLY OF THE TENT.

To prolong the life of the tent floor, select a level, clean area for the campsite.

Step 1 – Lay Out the Screenhouse and Poles Select a smooth, level site and spread out your screenhouse.

Sort the poles by number and connect the sections together. See diagrams below for numbering.

		R
	2	T
2B	2B
	2B	2	L
2B
	2B	2
2B	2B	2B
L	2B
		Diagram 1
T
R	hub	T
	5B		1

Insert the leg poles into the hubs to raise the screenhouse frame. Make sure that the pole end with the holes in the sides ( C ) is pointing down. See Diagram 3.

Step 3 –Secure the Screenhouse

Drape the screenhouse body over the frames.

Hook the S-Hooks B into one of the holes C located at the bottom of the leg poles.

Wrap the velcro tape D , located inside the screenhouse, around the poles to secure them.

When the screenhouse is in its proper location, stake it down by driving stakes through the four D-rings E located on at the corners.

Step 4 – Install the Guy Lines

Tie the loose end of a guy line through D-ring H

5 T

1B

11

L Diagram 2

5B		1B
R	5	L
		2
		2B
1B		2B
R	2B

Repeat for the other three guy lines.

Make a loop at the end of the guy line with the slider. Stake the looped end of the line out about 3' from the base of the pole. Adjust the slider until the line is taut G .

	2B	2			2
					2B
	2B	1B
	2B				2B
				2B	1B
1B
		1B	1B		1B
					C
1B		4
			1B		4
4	Diagram 3
				4

Step 2 – Install the Poles

Insert the ends of each of the three roof poles into the 3-way hubs A . See Diagram 1.

slider for adjusting guy line tension

Insert the four side roof poles into the 3-way hubs. See Diagram 2.