LaCie 12big rack Serial Mounting the System into the Rack, Securing Chassis Slides to Enclosure

LaCie 12big rack serial Quick Install Guide

Mounting the System into the Rack page 4

4.Mounting the System into the Rack

1.Remove the Rack Mounting Rail Kit from the Accessory

Box and check for damage.Attach the left and right chassis slides to the enclosure sides using six M3x4 but- ton head screws. Three screws each side see Figure 2 for locations.

2.Attach left and right chassis slides to the enclosure sides using 8 M3 x 4 buttonhead screws (see Figure 2).

3.Assemble the left and right chassis latches using the special chassis latch screws. Ensure the latch is orien- tated as shown in Figure 2, with the spring arm located against its stop. On the right hand side this is at the top, on the left at the bottom.

4.Assemble the rack brackets to the rack posts as follows (see Figure 3):

a.Position the location pin at the rear of the rail into a rear rack post hole. Attach the bracket to the rear rack post using the washers and screws supplied. The screws should be left loose.

b.Extend rail to fit between the front and rear rack posts.

c.Attach the bracket to the front rack post using the washers and screws supplied. The screws should be left loose.

d.Tighten the two clamping screws located along the in- side of the rear section of the rack bracket (see Figure 3).

Figure 2: Securing Chassis Slides to Enclosure

Figure 3: Securing Brackets to Rack